GE Dishwasher Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 17 codes covered.
Shop GE Dishwasher parts at RepairClinic
- 1H — On GE dishwashers, a number followed by H (for example 1H, 2H) is not an error: the dishwasher is in Delay Start mode and will start after…
- 815 — On GE GDF, GDT and PDT-series dishwashers from the mid-2010s, 815 appears in Consumer Error Mode (holding Cycle Select and Start for 5…
- 999 — On GE dishwashers with the Floor Protect with Alert feature, 999 means a possible leak has been detected and the dishwasher will not start…
- C1 — On GE dishwashers with electronic controls, C1 means the pump-out during drain has exceeded 2 minutes, so the dishwasher is draining too…
- C2 — On GE dishwashers with electronic controls, C2 means the total pump-out cycle has exceeded 7 minutes, indicating the drain line is…
- C3 — On GE dishwashers with electronic controls, C3 means the dishwasher will not drain at all and cannot switch into the drain mode.
- C4 — On GE dishwashers with electronic controls, C4 means the machine filled twice after a power failure, which GE attributes to a stuck or…
- C5 — On GE dishwashers with electronic controls, C5 means the pump-out time is too short, which usually points to a low-water or float problem…
- C6 — On GE dishwashers with electronic controls, C6 means the water temperature is too low; GE specifies the incoming water should be at least…
- C7 — On GE dishwashers with electronic controls, C7 means the water temperature sensor circuit has become inoperative.
- C8 — On GE dishwashers with electronic controls, C8 means the detergent cup is blocked from opening fully during the cycle.
- Cup Open — On GE dishwashers, Cup Open is a reminder, not a fault: the detergent cup has not been closed, so the cycle will not start until detergent…
- FTD — On GE dishwashers, FTD (also shown as F56 on some models) means failure to drain: the dishwasher did not drain at the end of the cycle.
- H2O — On GE dishwashers, H2O (sometimes read as H20 on the display) indicates a low water situation: the dishwasher is not getting enough water.
- LEAK DETECTED — On GE dishwashers with leak detection, LEAK DETECTED means a possible leak has been detected and the cycle will be cancelled.
- PF — On GE dishwashers with electronic controls, PF means there has been a power failure to the dishwasher; it is a notice, not a part failure.
- PrS — On GE dishwashers, PrS means the pressure sensor is sending an invalid signal to the control, so the dishwasher cannot start a cycle or…