Jacuzzi Hot tub FL--1 Error Code
What the FL--1 code means
On Jacuzzi J-300 Collection hot tubs, FL--1 (FLOW ERROR OPEN) means the flow switch is malfunctioning open, the filter cartridge is excessively dirty, or an air lock has occurred at the circulation or Jets Pump 1 intake. The heater deactivates.
Likely causes
- excessively dirty filter cartridge
- air lock at the pump intake
- low water level
- malfunctioning flow switch
How to fix it — step by step
- Turn power off at the breaker before removing the filter
- Verify water level is above all jets but below the lowest pillow and add water if needed
- Remove and clean or replace the filter cartridge
- Purge the air lock: remove the filter, hold a garden hose sealed with a rag over the filter wall fitting and run water for 30 seconds, then reinstall the filter
- Restore power to reset the pump priming cycle
- If FL--1 persists, contact your Jacuzzi dealer or a qualified spa technician
Parts that commonly fix the FL--1 code
- flow switch - Shop at RepairClinic
- filter cartridge - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.