Samsung Oven Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 20 codes covered.
Shop Samsung Oven parts at RepairClinic
- bAd LinE — Bad line: the power connection is not plugged in / installed properly. The manual form is 'Bad line' and the US support display form is…
- C-20 — Oven sensor malfunction: the oven sensor is open when the oven is operating, or there is a short in the oven sensor. Samsung groups C-20…
- C-21 — Sensor malfunction / overheating: this code occurs if the internal oven temperature rises abnormally high.
- C-22 — Sub PCB sensor malfunction: the sub PCB sensor is open when the oven is operating, or there is a short in the sub PCB sensor. Samsung…
- C-23 — Temperature probe sensor fault: the temp probe sensor is shorted when the oven is operating.
- C-24 — The temperature sensor has detected the oven temperature rising faster than the normal rate, generally caused by the vent on the back of…
- C-30 — Main PCB sensor fault: the main PCB sensor is open when the oven is operating, or there is a short in the main PCB sensor.
- C-31 — PCB overheating: this code occurs if the PCB temperature rises abnormally high, treated as a safety error in service data.
- C-70 — Steam sensor fault on steam ovens: the steam sensor is open when the steam mode is operating, or shorted when the oven is operating.
- C-72 — Steam oven drain problem: there is a drain system-related problem, when the water level sensor senses water remaining after the maximum…
- C-A2 — Sub PCB overheating: this code occurs if the sub PCB temperature rises abnormally high.
- C-d0 — Button / control key problem: there is a short in the control key, displayed when a button is pressed and held for a period of time. On…
- C-d1 — Door lock malfunction: the door lock is misaligned / mispositioned.
- C-F0 — Communication error: communication between the main and sub PBA/PCB is interrupted. On certain induction models (NSI6D*9100, NSI6D*9300…
- E-08 — Oven not heating / oven heating error on older Samsung ranges: the oven was called to heat but did not heat. Also written as E08.
- E-0A — Oven overheating / oven heating over error on older Samsung ranges.
- E27 — Oven temperature sensor is defective (electrically open) on older Samsung electric ranges: its resistance is over 2950 ohms instead of…
- E28 — Oven temperature sensor is defective (electrically shorted) on older Samsung electric ranges: its resistance is under 930 ohms instead of…
- SE — Defective / shorted key on the control panel, on older Samsung ranges. This is the older equivalent of the newer C-d0 stuck-key code.
- tESt — Demo mode: the range is in Demo mode (also shown as tE5t), so the oven and cooktop will not heat, although gas cooktops will still ignite.…