Whirlpool Refrigerator Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 14 codes covered.
Shop Whirlpool Refrigerator parts at RepairClinic
- 6 — On the older single-letter / digit platform, a '6' on the refrigerator display is a computer (control) error; a flashing 6 can also simply…
- C — A thermistor (temperature sensor) failure on the older single-letter platform: C on the refrigerator display means the fresh-food…
- CE — A communication error in the system / ice maker controls on service data sheets for Whirlpool bottom-freezer models - for example, no…
- CF — Communication failure between the main control board and the user interface control, shown on the freezer display on the older side-by-side…
- COOLING OFF — Cooling has been switched off at the control panel - not a failure. The lights and display still work, but neither the refrigerator nor the…
- d — The air damper is stuck: the motorised baffle that lets cold air from the freezer into the refrigerator compartment is jammed or not…
- Demo — Demo / showroom mode is on (display may read Demo, Showroom or Shwrm): the display and lights work normally but the compressor and fans…
- Door Ajar — The door ajar alarm: a refrigerator door or the freezer drawer has been open for about 5 minutes (2-5 minutes on some models) while cooling…
- E1 — The refrigerator compartment temperature sensor / thermistor is defective, so the control cannot read fresh-food temperature correctly.…
- E2 — The freezer compartment thermistor / temperature sensor is defective, which can lead to excess ice formation and poor temperature control.
- E3 — The defrost sensor is faulty, so defrost cycles are not controlled correctly and temperature and frost problems follow.
- H2O — The H2O / water filter status light: the water filter is due for replacement (about every 6 months). A red H2O light is a maintenance…
- PO — Power outage indicator, not a part failure: power was off and the freezer temperature rose to 18F (-8C) or higher. PO flashes repeatedly…
- Sabbath Mode — Sabbath mode is on - a setting, not a fault: temperature set points stay unchanged, but interior and dispenser lights turn off, sounds and…