Hayward Pool pump DC voltage too high
What this problem usually means
On Hayward TriStar VS 900 variable-speed pool pumps (Check System message), DC voltage too high means the drive DC bus voltage has risen above 400 VDC; the manual says to verify line voltage is within 10% (207-253 VAC) of the pump rated voltage.
Likely causes
- supply voltage too high
- voltage surge
- incorrect wiring voltage
How to fix it — step by step
- Stop the pump and turn power off at the breaker
- Note the message for the technician
- Do not measure or rewire the terminal block unless you are qualified
- If the message returns after one power cycle, call a licensed electrician or pool technician
Parts that commonly fix it
- drive - Shop at RepairClinic
- motor drive - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.