Rheem Furnace 11 Error Code
What the 11 code means
Failed ignition on Rheem furnaces with the 7-segment diagnostic display. The burners did not light during the ignition trial.
Likely causes
- failed or cracked igniter
- no gas supply or closed gas valve
- dirty flame sensor
- gas valve fault
How to fix it — step by step
- Check the thermostat is set to Heat and the furnace power switch and breaker are on
- Confirm the manual gas shutoff valve near the furnace is open (handle parallel to the pipe)
- Turn power off for 30 seconds, then back on, and allow one retry cycle
- Do not keep resetting a furnace that repeatedly fails to light
- If it locks out again, call a licensed HVAC technician and note the code
Parts that commonly fix the 11 code
- hot surface igniter - Shop at RepairClinic
- flame sensor - Shop at RepairClinic
- gas valve - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.