GE Washer E23 Error Code
What the E23 code means
Flood-protect / overfill fault on GE front-load washers: the washer detected too much water, or the foam/level switch closed while the washer was idle, and ran a protective drain.
Likely causes
- Water inlet valve not shutting off properly
- Failed water level (pressure) sensor giving a false high reading
- Excess suds from too much or non-HE detergent fooling the level sensing
- Loose or damaged wiring to the water level sensor
How to fix it — step by step
- Turn off both water supply valves and unplug the washer
- If the tub is overfilled, let it drain and check whether water keeps entering with the power off - if it does, keep the valves shut
- Use less HE detergent and run a rinse to clear excess suds
- Do not keep running cycles if the code returns
Parts that commonly fix the E23 code
- water inlet valve assembly - Shop at RepairClinic
- water level sensor - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.