LG Dryer Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 18 codes covered.
Shop LG Dryer parts at RepairClinic
- Add — Add water message: a water supply reminder for steam cycles - the steam feeder must be filled with water before a steam cycle can run.
- CL — Child lock / control lock is active - this is not an error. The control panel is disabled and settings cannot be adjusted while it is on.
- d75 — Flow Sense warning: the dryer's exhaust duct is clogged or restricted by about 75%, so hot humid air cannot vent properly.
- d80 — Flow Sense warning: the dryer's exhaust duct is clogged or restricted by about 80%. On gas dryers, d80 can also indicate a lack of gas…
- d90 — Flow Sense warning: the dryer's exhaust duct is clogged or restricted by about 90% - a severe restriction that causes long, hot cycles.
- d95 — Flow Sense warning: the dryer's exhaust duct is clogged or restricted by about 95% - the most severe reading, and the dryer may cool down…
- dE — Door error: the dryer door is not completely closed, so the dryer will not run properly.
- E13 — Drain error on hybrid condensing dryers only: the drain hose is kinked, crushed or clogged, or the water in the sump is frozen.
- FO — Filter out error (also shown as F0 or a flashing Insert Filter message): the lint filter is not inserted in the dryer.
- gAS — Gas supply error (gas models only): the dryer is not receiving gas, because the gas supply or service is turned off.
- HS — Humidity sensor error: the dryer has detected an error with its humidity (moisture) sensor, and may run for about 2.5 hours, seeming not to…
- nP — No power / no current error: no current is being detected at the heater, which normally indicates a problem with the electrical wiring in…
- PF — Power failure: the code often appears after a power outage and usually clears with a factory reset.
- PS — Power supply error: there is improper voltage in the power cord, which can be caused by the white and red wire connections being reversed…
- tE1 — Thermistor error: a problem was detected with the dryer's thermistor (temperature sensor).
- tE2 — Thermistor error that normally appears in cold conditions: extra humidity during steam cycles cools the duct faster and triggers the code.
- tE3 — Thermistor error: a problem was detected with the dryer's thermistor (temperature sensor), like tE1.
- tE4 — Thermistor error: the temperature in the dryer is reading out of range.