OBD-II Car P0402 Error Code

What the P0402 code means

Exhaust Gas Recirculation (EGR) Flow Excessive Detected: the computer detected more EGR flow than commanded, typically at idle, which can make the engine surge or run rough off idle. Counter-intuitively, the most common cause is not a stuck valve but the DPFE sensor lying about flow - per the reference for this code, replacing the EGR valve alone usually brings the code back, while the DPFE sensor is the most likely fix.

Likely causes

  1. Faulty DPFE (differential pressure feedback EGR) sensor (most likely)
  2. EGR valve stuck open or held open by a chunk of carbon
  3. Carbon blockage distorting the pressure signal the DPFE reads
  4. EGR valve not closing due to a vacuum control fault

How to fix it — step by step

  1. Check the DPFE sensor voltage at idle and with the EGR valve open, and compare with the spec for your vehicle
  2. Inspect the DPFE hoses for cracks, melting, or blockage and replace them if deteriorated
  3. Replace the DPFE sensor if readings are out of spec - this resolves most P0402 codes
  4. If the sensor checks out, remove the EGR valve and verify the pintle seats fully closed; clean or replace the valve if carbon is holding it open

Parts that commonly fix the P0402 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related OBD-II car error codes

See all OBD-II car codes & guides →