Payne Furnace 25 Error Code

What the 25 code means

Invalid model selection or setup error, documented on the Payne PG96VTA variable-speed two-stage furnace. If code 25 flashes only 4 times at power-up, the control is missing its model plug PL4 and is defaulting to the model stored in memory; continuous flashing means the plug is missing with no valid stored model, a setup switch is wrong, or two different models were twinned.

Likely causes

  1. Model plug PL4 missing (common after a replacement control board)
  2. Setup switch SW1-1 or SW1-6 left in the wrong position
  3. Two different furnace models twinned together
  4. Incorrect service replacement control

How to fix it — step by step

  1. Note the code and when it first appeared (especially if a board was just replaced)
  2. Do not move setup switches or swap plugs yourself
  3. Cycle power once at the service switch; if 25 returns, stop
  4. Call the technician who serviced the furnace to fit the correct model plug and set the switches

Parts that commonly fix the 25 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Payne furnace error codes

See all Payne furnace codes & guides →