Shark Robot vacuum CLEAN (BLUE) + DOCK (RED) solid
What this problem usually means
Error number 14 in Shark IQ / EZ manuals: BotBoundary error. The robot is on or too close to a BotBoundary magnetic boundary strip.
Likely causes
- Robot started on top of a BotBoundary strip
- Robot too close to the magnetic boundary strip to navigate away
- Boundary strips set up incorrectly
How to fix it — step by step
- Pick the robot up off the boundary strip
- Move it to a flat surface well away from the magnetic boundary strip
- Check the boundary strips are laid out correctly
- Try cleaning again
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Related Shark robot vacuum problems
- CLEAN (RED) + ! (RED) flashing
- CLEAN (RED) + DOCK (BLUE) + ! (RED) flashing
- CLEAN (RED) + DOCK (BLUE) alternating
- CLEAN (RED) + DOCK (BLUE) flashing
- CLEAN (RED) + DOCK (RED) + ! (RED) flashing
- CLEAN (RED) + DOCK (RED) flashing
- CLEAN (RED) flashing
- CLEAN (WHITE) + DOCK (RED) + ! (RED) flashing
- DOCK (RED) + ! (RED) flashing
- DOCK (RED) flashing
- ALL LED LIGHTS are off
- BATTERY ICON (RED) flashing