OBD-II Car P0325 Error Code

What the P0325 code means

Knock Sensor Circuit Malfunction (Bank 1): the knock sensor - a microphone-like sensor bolted to the engine block that listens for damaging detonation ("knock" or "ping") - or its circuit is faulty. Without a believable knock signal the computer typically retards ignition timing to protect the engine, which costs power and fuel economy. This code is especially common on Honda, Acura, Nissan, Toyota, and Infiniti vehicles.

Likely causes

  1. Failed knock sensor (most likely)
  2. Short, open, or damaged wiring in the knock sensor circuit - the harness often runs under the intake manifold and suffers heat and rodent damage
  3. Corroded or loose knock sensor connector
  4. Failed engine computer (PCM) - rare, test everything else first

How to fix it — step by step

  1. Inspect the knock sensor connector and as much of its harness as you can reach for breaks, chafing, corrosion, or rodent damage
  2. Measure the knock sensor's resistance and compare it with the factory specification for your vehicle
  3. Check continuity of the wiring between the sensor connector and the PCM
  4. Replace the knock sensor if it tests out of spec or the wiring proves good - note that on many V-engines the sensor sits under the intake manifold, so budget time or replace the sub-harness while you're in there
  5. Clear the code and road test, including a hill under load, to confirm it doesn't return

Parts that commonly fix the P0325 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related OBD-II car error codes

See all OBD-II car codes & guides →