Payne Furnace 14 Error Code
What the 14 code means
Ignition lockout. On Payne furnaces such as the PG92ESA, PG95ESA and PG96VTA, code 14 means the furnace failed to ignite the gas and prove flame in four attempts. The control auto-resets after 3 hours; see code 34 for the underlying fault.
Likely causes
- Failed hot surface igniter
- Dirty or failed flame sensor
- Low inlet gas pressure or a closed manual gas valve
- Defective gas valve
How to fix it — step by step
- Confirm the thermostat is calling for heat
- Check that other gas appliances in the home work, so you know gas service is on
- Make sure the manual gas shutoff valve near the furnace is open
- Turn power off at the service switch for one minute, then back on for one clean retry
- If the furnace locks out again, call a technician - do not keep resetting it
Parts that commonly fix the 14 code
- hot surface igniter - Shop at RepairClinic
- flame sensor - Shop at RepairClinic
- gas valve - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.