OBD-II Car P0302 Error Code

What the P0302 code means

Cylinder 2 Misfire Detected: the powertrain control module has detected a misfire specifically in cylinder #2. Per the ASE-authored reference for this code, single-cylinder misfires are most often an ignition defect (weak or no spark), followed by fuel delivery problems; the code is classed as severe because a persistent misfire can damage the catalytic converter.

Likely causes

  1. Defective ignition coil for cylinder 2
  2. Bad spark plug, plug wire, or plug boot on cylinder 2
  3. Faulty fuel injector for cylinder 2
  4. Fuel delivery problem - weak pump, clogged filter, or faulty regulator
  5. Large vacuum leak affecting cylinder 2
  6. EGR valve stuck wide open or clogged EGR ports dumping gas into one cylinder

How to fix it — step by step

  1. Visually inspect cylinder 2's coil, plug, and boot - clean or replace anything contaminated with oil, coolant, or water in the plug well
  2. Swap cylinder 2's coil with a neighbouring cylinder's coil, clear codes, and retest: if the code moves to that cylinder, replace the coil (and the plug and boot with it)
  3. If spark tests strong, test the injector by unplugging it while the engine runs - no RPM change means that injector isn't firing; check it for power and ground pulse
  4. Diagnose and fix any lean or fuel-supply codes before chasing the misfire - they can cause it
  5. If spark, fuel, and EGR all check out, compression-test cylinder 2

Parts that commonly fix the P0302 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related OBD-II car error codes

See all OBD-II car codes & guides →