Payne Furnace 12 Error Code

What the 12 code means

Blower on after power up - normal operation on Payne furnaces such as the PG92ESA, PG95ESA, PG96VTA and PG80MSU. The blower runs for 90 seconds because power was restored during a call for heat, or the call ended during the blower on-delay. It is not a fault.

Likely causes

  1. Power was interrupted and restored during a call for heat
  2. The thermostat call ended during the blower on-delay period

How to fix it — step by step

  1. Wait about 90 seconds - the blower should stop on its own
  2. Confirm the thermostat is set to Heat and the furnace then runs a normal cycle
  3. No reset is needed
  4. If code 12 keeps appearing with no power outages, have a technician check for a loose power connection or failing door switch

Parts that commonly fix the 12 code

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Payne furnace error codes

See all Payne furnace codes & guides →